Steel City 35635 User Manual page 24

Fig. 16
5. Tighten locknut (A)
6. Set the blade at 45 degrees to the table by turning
the blade tilting handwheel counterclockwise as far
as it will go. Place a square on the table.
SEE FIG. 16.
7. If the blade is not at 45 degrees, loosen lock nut
(D) and turn adjusting stop screw (E) on the front
trunnion (C) in or out. The adjusting stop screw (E)
should stop against the front trunnion bracket when
the blade is 45 degrees to the table.
SEE FIG 15.
8. Check the accuracy of the pointer on the angle
scale and adjust if necessary.
MOUNTING RAILS, FENCE
AND EXTENSION TABLE
With the extension wings properly aligned, the rail and
fence assembly can now be mounted to the saw.
See the Owner's Manual for the Fence Assembly
Instructions. This will address the mounting of the rails
and fence.
24