Table of Contents
Advertisement
Optical lens focusing
The optical focusing procedure is performed separately for each
lens. The appropriate CRT will be switched on as the user proceeds
through the optical focusing adjustment sequence.
Each lens has two focus adjustment points, one at the rear of the lens
and one at the front. The center of the projected image is focused by
loosening the wing nut at the rear end of the lens and rotating the lens
barrel until the center of the image is clearly focused. The corners of
the projected image are focused by loosening the wing nut at the
front end of the lens and rotating the lens barrel until the corners of
the image are clearly focused. Repetition of these adjustments may
be necessary to optimize optical focusing.
Press ENTER key to continue.
ENTER continues to Raster centering.
EXIT returns to scheimpfug adjustment
ADJUST returns to operational mode.
Electrical focusing
The electrical focus for red, green and blue is factory preset. When
they have to be readjusted, follow the procedure as described below:
- Ensure the lenses are correctly focused.
- Open the top cover.
- Adjust separately the focus control for red, green and blue for the
sharpest image on the screen.
5975987 BARCODATA 708 260597
Installation Adjustments
OPTICAL LENS FOCUSING
1. LOOSEN THE NUT ON THE
REAR OF THE XXXX LENS,
ROTATE THE LENS BARREL
TO FOCUS THE CENTER
OF THE IMAGE,
THEN TIGHTEN THE NUT
2. LOOSEN THE NUT ON THE
FRONT OF THE XXXX LENS
AND ROTATE THE FRONT
SECTION OF THE LENS TO
FOCUS THE CORNERS OF THE
IMAGE, THEN TIGHTEN THE NUT.
<ENTER> to continue
<EXIT> to return
XXXX = respectively red, green and blue.
Center
focusing
Electrical focus
Red Green Blue
Corner
focusing
7 - 5
Advertisement
Table of Contents
