Table of Contents
Advertisement
Configuring the RemotEye II via HTTP
The RemotEye II can be configured by opening a web session with the device.
Hardware Setup
Web configuration is accomplished through a network link. Follow these steps to
prepare the hardware for HTTP RemotEye II configuration:
1.
Verify network cable connection to NETWORK port of RemotEye II.
2.
Verify active link to LAN or Network.
3.
For further information on the network connection, refer to Making the
Network Connection on page 20.
Software Setup
The web configuration is accomplished through a TCP/IP network connection. A web
connection can be established with RemotEye II by using any Internet Browser
application (for example, Netscape). Follow these steps to setup the software for
web-based RemotEye II configuration:
1.
Verify workstation is loaded with web browser application.
2.
Verify a valid network path exists between RemotEye II and the workstation.
If performing the web configuration from a workstation that is located on the
same network, then proceed to the next section; otherwise, refer back to the
section entitled Routing to the RemotEye II on page 43.
45
Hide quick links:
Advertisement
Table of Contents
