Getting Started; Setting The Time Of Day; Securing The Controls; Oven Features - Dacor ECD Series Use And Care Manual

Getting Started

Before using your oven, become familiar with the features and
control panel layout (see pages 4 and 5).
Below the oven mode touch keys are three touch keys
labeled CANCEL • SECURE, lIght and CooK tIme. the
CANCEL•SECURE key enables the user to cancel the selection
of an oven mode or delay timed program, or disable the control
panel. the lIght key turns the interior oven light on and off. the
lIght key will remain functional if the control panel has been
disabled. the CooK tIme key is used to select the length of time
for a cooking process in delay timed cooking mode.
Clock functions are selected by pressing the keys located below
the clock display and oven mode keys. oven functions are chosen
by pressing the key for the desired mode. once a clock or oven
function has been chosen, a description of the selection will flash
in the clock display area.
Important: after choosing a clock function or oven mode, you
have six seconds to perform the next programming step. if the
next step is not complete within six (6) seconds, the program
selection displayed on the clock will disappear. Should this occur,
just repeat the initial function selection.
o o
ven peratIon

Setting The Time Of Day

follow these two steps to set the correct time of day:
1.
2.

Securing the Controls

to avoid accidentally turning the oven on, activate the secure
feature. Press and hold the CANCEL • SECURE key for
approximately three seconds. Doing so will disable the control
panel and allow cleaning the controls without accidentally starting
any functions. three beeps will sound and "off" will appear in
the display when the control panel has been secured.
to re-activate the control panel, again push and hold the CanCel
• SECURE key for three seconds. three beeps will sound and
"off" will disappear from the display.

oven features

3
Press the CloCK key. the time of day will flash, "am" or
"pm" will be displayed, and "tIme" will flash in the display.
Press the key "+" or "–" until the correct time of day is
displayed and release.