Replacing The Secondary Hard Disk Drive - Lenovo 10A2 User Manual

Replacing the secondary hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the secondary hard disk drive.
To replace the secondary hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 36.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 36.
4. Press the retaining clip
same time.
Figure 81. Pivoting the drive bay assembly upward
5. Locate the secondary hard disk drive bay. See "Locating internal drives" on page 17.
6. Disconnect the signal cable and the power cable from the primary hard disk drive and secondary
hard disk drive.
1 in the direction as shown and pivot the drive bay assembly upward at the
.
Chapter 5 Installing or replacing hardware
79