4. Gently pivot the two plastic retaining clips that secure the heat sink fan duct outward, and then lift the
heat sink fan duct out of the chassis.
Figure 56. Removing the heat sink fan duct
5. Press the retaining clip
same time.
Figure 57. Pivoting the drive bay assembly upward
6. Record the cable routing and cable connections. Then, disconnect the power supply assembly cables
from the system board and all drives.
7. Release the power supply assembly cables from any cable clips or ties that secure the cables to the
chassis.
1
in the direction as shown and pivot the drive bay assembly upward at the
.
Chapter 5
Installing or replacing hardware
63