Replacing The Wi-Fi Units - Lenovo 10A2 User Manual

9. Insert the connector and cable of the new thermal sensor into the hole
two tabs on the plastic holder holding the thermal sensor with the two holes
and push the plastic holder until it snaps into position.
Figure 98. Installing the thermal sensor
10. Connect the cable of the new thermal sensor to the thermal sensor connector on the system board. See
"Locating parts on the system board" on page 14.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 103.

Replacing the Wi-Fi units

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the Wi-Fi units. The Wi-Fi units include a Wi-Fi adapter
card, a Wi-Fi card module and a rear Wi-Fi antenna cable.
Replacing the Wi-Fi units includes the following operations:
• "Removing the Wi-Fi adapter card" on page 92
• "Removing the Wi-Fi card module" on page 93
• "Installing the Wi-Fi units" on page 94
1 in the chassis. Then, align the
1 and 2
.
Chapter 5 Installing or replacing hardware
in the chassis,
91