Replacing The Cover Presence Switch - Lenovo 10A2 User Manual

11. Note the orientation of the new microprocessor. Hold the new microprocessor by its edges and align
the notches 1 on it with the tabs
microprocessor straight down into the microprocessor socket.
Note: The small triangle
indicator. The new microprocessor is in the correct orientation when this indicator faces the beveled
4
corner of the microprocessor socket.
Figure 67. Installing the microprocessor
12. Close the microprocessor retainer and lock it into position with the small handle to secure the new
microprocessor in the socket.
13. Reinstall the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 65.
14. Reconnect all cables that were disconnected from the system board. See "Locating parts on the
system board" on page 14
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to "Completing the parts replacement" on page 103.

Replacing the cover presence switch

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the cover presence switch, which is also known as
intrusion switch.
To replace the cover presence switch, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
70
ThinkCentre M83, M93/p User Guide
2 in the microprocessor socket. Then, carefully lower the new
3 on one corner of the new microprocessor is the microprocessor orientation