Wireless Settings Screen Fields - NETGEAR N300 User Manual

N300 Wireless ADSL2+ Modem Router DGN2200v3
1. Select Basic > Wireless to display the Wireless Settings screen.
The screen sections, settings, and procedures are explained in the following sections.
2. Make any changes that are needed and click Apply to save your settings.
3. Set up and test your wireless devices and computers to make sure that they can connect
wirelessly. If they do not, check the following:
• Is your wireless device or computer connected to your network or another wireless
network in your area? Some wireless devices automatically connect to the first open
network (without wireless security) that they discover.
• Does your wireless device or computer show up on the Attached Devices screen? If it
does, then it is connected to the network.
• If you are not sure what the network name (SSID) or password is, look on the label on
the bottom of your modem router.

Wireless Settings Screen Fields

Region Selection
The location where the modem router is used. Select from the countries in the list. In the
United States, the region is fixed to United States and is not changeable.
Wireless Network (2.4 GHz b/g/n)
The b/g/n notation references the 802.11 standards of conformance for the 2.4 GHz radio
frequency.
Enable Wireless Isolation. If this check box is selected, computers or wireless devices that
join the network can use the Internet, but cannot access each other or access Ethernet
devices on the network.
Enable SSID Broadcast. This setting allows the modem router to broadcast its SSID so
wireless stations can see this wireless name (SSID) in their scanned network lists. This check
NETGEAR genie Basic Settings
34