Use Manual Policy To Configure Vpn Tunnels - NETGEAR N300 User Manual

N300 Wireless ADSL2+ Modem Router DGN2200v3

Use Manual Policy to Configure VPN Tunnels

As an alternative to IKE, you can use manual keying, in which you need to specify each
phase of the connection. A manual VPN policy requires all settings for the VPN tunnel to be
manually input at each end (both VPN endpoints).
Select Advanced - VPN > VPN Policies, and then click the Add Manual Policy radio button
to display the VPN - Manual Policy screen:
The following sections explain the fields in the VPN Manual Policy screen.
VPN Manual Policy General Settings
The DGN2200v3 VPN tunnel network connection fields are as follows.
• Policy Name. Enter a unique name to identify this policy. This name is not supplied to the
remote VPN endpoint. It is used only to help you manage the policies.
• Remote VPN Endpoint. The remote VPN endpoint has to have this VPN gateway's
address entered as its remote VPN endpoint.
If the remote endpoint has a dynamic IP address, select Dynamic IP Address. No
address data input is required. You can set up multiple remote dynamic IP policies, but
only one such policy can be enabled at a time. Otherwise, select an option (IP address or
domain name) and enter the address of the remote VPN endpoint to which you want to
connect.
VPN Manual Policy Local LAN Settings
The remote VPN endpoint has to have these IP addresses entered as its remote addresses.
• Subnet Address. Enter the network mask.
• Single PC - no Subnet. Select this option if there is no LAN (only a single PC) at the
remote endpoint. If this option is selected, no additional data is required.
Virtual Private Networking
132