Technical Specifications - HP ProLiant DL980 Specification

Hp proliant dl980 generation 7 (g7)
Hide thumbs Also See for ProLiant DL980:
Table of Contents

Advertisement

QuickSpecs

Technical Specifications

System Unit Rack
Dimensions (H x W x D)
(with bezel and XNC cables
installed)
Weight
(approximate)
Input Requirements
(per power supply)
BTU Rating
Power Specifications
Power Supply Output
(per power supply)
System Inlet
Temperature
Relative Humidity
(non-condensing)
Altitude
DA - 13708 North America — Version 38 — September 23, 2013
13.92 x 19.0 x 34.5 in (35.36 x 48.26 x 87.63 cm)
Maximum
(all hard drives, power
supplies, and processors
installed)
Minimum
(one hard drive, power
supply, and processor
installed)
Rated Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
Maximum
Maximum
NOTE: To review typical system power ratings use the HP Power Advisor
which is available online located at url:
efficient
or
www.hp.com/go/hppoweradvisor
- Click on the system of interest. Example: DL980 G7
- Follow the instructions of the next screens.
Rated Steady-State Power 1200W @ 200 - 240VAC
Maximum Peak Power
Operating
Non-operating
Operating
Non-operating
Operating
HP ProLiant DL980 Generation 7 (G7)
205 lb (93 kg)
165 lb (75 kg)
200 - 240 VAC
6.6A @ 200-240VAC
50 - 60 Hz +/- 3hz
1375W @ 200-240VAC
14,330 BTU/hr (worst case configuration and
utilization)
4200 W (worst case configuration and utilization)
www.hp.com/go/proliant-energy-
1440W @ 200 - 240VAC
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m (1.8°F
per every 1000 ft) above sea level to a maximum
of 3050 m (10,000 ft), no direct sustained
sunlight. Maximum rate of change is 10°C/hr
(18°F/hr). The upper limit may be limited by the
type and number of options installed.
System performance may be reduced if operating
with a fan fault or above 30°C (86°F).
-30° to 60°C (-22° to 140°F). Maximum rate of
change is 20°C/hr (36°F/hr).
10 to 90% relative humidity (Rh), 28°C (82.4°F)
maximum wet bulb temperature, non-
condensing.
5 to 95% relative humidity (Rh), 38.7°C (101.7°F)
maximum wet bulb temperature, non-
condensing.
3050 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 457
Page 45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proliant dl980 generation 7

Table of Contents