Table of Contents
Advertisement
LUBRICATION
3. Right wheel
Lubricate using a grease gun until the grease
squeezes out, 1 nipple.
Use good quality MP grease. Grease from well-
known brand names (petrochemical companies,
etc.) usually maintains a good quality.
8011-231
Lubricating the cables
Grease both ends of the cables and move the
controls to end stop positions when lubricating.
Refit the rubber covers on the cables after
lubrication. Cables with sheaths will bind if they are
not lubricated regularly. Binding in a cable may
cause malfunction such as partial braking.
If a cable binds, remove the cable and hang it
vertically. Lubricate it with thin engine oil until the oil
begins to escape from the bottom. Tip: Fill a small
plastic bag with oil and tape it so that it seals
against the casing and allow the cable to hang
vertically from the bag overnight. If you do not
succeed in lubricating the cable, it must be
replaced.
4. Brake cable
Peel back the rubber cover at the upper cable
mounting. Lubricate using an oilcan. Refit the
rubber cover.
8011-232
5. Throttle cable
Peel back the rubber covers at both of the cable
mountings. Lubricate at the ends using an oilcan.
Coax oil into the throttle control. Refit the rubber
covers.
8011-234
8011-233
36 – English
Advertisement
Table of Contents
