Table of Contents
Advertisement
5.
Hold in the the dead man's grip bar and start
the engine.
6.
Allow the engine to warm up for two minutes at
idle before grinding.
7.
Tilt the machine on its wheels, lifting the cutting
wheel off the ground/tree stump.
8.
Set the throttle to ENGAGE.
IMPORTANT INFORMATION
If the cutting wheel is too low, the machine
may start to "climb" over the stump and
become instable.
9.
Place the middle of the cutting wheel
approximately 2.5 cm above and 2–4 cm into
the stump.
10. Place the cutting wheel in the upper front edge
of the stump. Swing the cutting wheel from side
to side while lowering it about 2.5 cm after
each pass until the front edge of the stump is
gone.
24 – English
RUNNING
8011-185
8011-127
8011-202
8011-194
8011-203
Advertisement
Table of Contents
