Switching The Headset On; Establishing Bluetooth Connections - Sennheiser EZX 60 Instruction Manual

5 s
Searching mode
5s
Standby mode
5s
Call establishment
4s
Active call mode
4s
When the battery is about to run flat:
• The LED flashes three times every 5 seconds.
• A low battery warning (five beeps) is heard in the headset every
20 seconds.
• You have several minutes of battery reserve. When the battery is
empty, you first hear the five warning beeps and then a descending
sequence of tones in the headset. The headset switches off.

Switching the headset on

To switch the headset on:
Press the multi-function button
An ascending confirmation beep is heard in the headset and the LED
flashes twice. The LED
When the LED
battery is almost empty.
The LED flashes once every 5 seconds:
The headset is paired to one or several Bluetooth devices and tries to
connect to one of these devices.
The LED flashes once every 5 seconds:
The headset is paired to one Bluetooth device and connected but
– there is currently no active call or
– it has not been used for more than 1 hour.
The LED flashes three times every 4 seconds:
The headset is paired to a Bluetooth device and is currently establishing a
call connection.
The LED flashes two times every 4 seconds:
The headset is paired to a Bluetooth device and there is currently an active
call.

Establishing Bluetooth connections

If the EZX 60 is not yet paired to any device, see "Pairing the headset" on
page 12.
WARNING Danger of malfunction!
The transmitted radio waves can impair the operation of
sensitive and unprotected devices.
Only use the headset in aircraft where wireless Bluetooth
transmission is permitted.
After switch-on, the headset tries to connect to the Bluetooth
device to which it was last connected. If this device cannot be
detected, the headset will go into standby mode.
Putting the EZX 60 into operation
for at least 5 seconds.
then indicates the current operating mode.
flashes three times every 5 seconds, the
11