7.32 SYNCHRONIZE CACHE (35)
Byte
7
6
0
1
LUN
2
(MSB)
3
4
5
6
7
(MSB)
8
9
VU = 0
Figure 114. SYNCHRONIZE CACHE (35)
The SYNCHRONIZE CACHE Command ensures that logical blocks in the cache have their most recent
data value recorded on the media.
Logical Block Address is to specify:
where the operation is to begin.
Number of Blocks specifies:
the total number of contiguous logical blocks within the range. Number of Blocks of zero indicates
that all remaining logical blocks on the logical unit shall be within the range.
Immed (immediate) must be zero.
An immediate bit of zero indicates that the status shall not be returned until the operation has com-
pleted.
If the Immed bit is set to one, the drive returns a Check Condition status. The sense key shall be set to
Illegal Request and the additional sense code shall be set to Invalid Field in CDB.
RelAdr (Relative Address) must be zero.
The drive does not support the relative addressing.
If the RelAdr bit is set to one, the drive returns Check Condition status. The sense key shall be set to
Illegal Request and the additional sense code shall be set to Invalid Field in CDB.
148
O E M Spec. of DDRS-3xxxx
Bit
5
4
3
Command Code = 35h
Reserved = 0
Logical Block Address
Reserved = 0
Number of Blocks
Reserved = 0
2
1
0
Immed RelAdr
= 0
= 0
(LSB)
(LSB)
FLAG
LINK