IBM DDRS-39130 - Ultrastar 9.1 GB Hard Drive Specifications page 219

Key Code Qual
2h 40h 85h
3h 0Ch 03h
3h 10h 00h
3h 11h 00h
3h 14h 01h
3h 16h 00h
3h 19h 00h
3h 31h 01h
4h 11h 00h
4h 19h 00h
4h 32h 00h
4h 40h 80h
4h 40h 85h
4h 44h 00h
4h 81h 00h
5h 1Ah 00h
5h 20h 00h
5h 21h 00h
5h 24h 00h
5h 25h 00h
5h 26h 00h
6h 28h 00h
6h 29h 00h
6h 2Ah 00h
6h 2Ah 02h
6h 2Fh 00h
6h 3Fh 01h
6h 5Dh 00h
Bh 00h 00h
Bh 1Bh 00h
Description
Diag Fail - R A M Microcode Not Loaded.
Medium error. Recommend Reassign.
Medium error. ID C R C error.
Medium error. Unrecovered read error.
Medium error. Record not found.
Medium error. Data synchronization mark error. (DAM error)
Medium error. Defect list error. A defect list error occurs when a data error
is detected while reading the manufacturing defect list or while reading or
writing the grown defect list.
Medium error. Medium Format Corrupted Reassign Failed
Hardware Error. Unrecovered read error in reserved area.
Hardware Error. Defect list error.
Hardware Error. No defect spare location available. A "no defect spare
location available sense code" indicates that the Reassign Block command
can not proceed the process because all spare sectors have been used, or it
will exceed implementation limitation of defect handling of the file.
Degrade Mode. Diagnostic Fail. Configuration sector valid check fail.
Reserved area sector valid check fail.
Degrade Mode. R A M Microcode Not Loaded.
Hardware Error. Internal target failure.
Hardware Error. Internal logic error.
Illegal request. Parameter list length error. The number of parameters sup-
plied is not equal to the value the expected.
Illegal request. Illegal command operation code. This command is also
returned when an unsupported command code is received.
Illegal request. Logical block address out of range.
Illegal request. Invalid field in CDB.
Illegal request. Invalid lun.
Illegal request. Invalid fields in the parameter list.
Unit attention. Not ready to ready transition.(Format completed)
Unit attention. Power on reset or Bus device reset occurred.
Unit attention. Parameters changed.
Unit attention. Log select parameters changed.
Unit attention. Command cleared by another initiator.
Unit attention. Micro code has been changed.
Predictive Failure Analysis threshold reached on
Aborted command. No additional sense code.
Aborted command. Synchronous data transfer error. (Extra ack detected)
209
SCSI SENSE DATA