Table of Contents
Advertisement
Loading Roll Media
Open the upper cover.
13.
[80]
While gently pulling out the center of the leading edge of the roll media as far as the
14.
cutter groove (e), align the right edge of the media so it is parallel to guideline (f),
then pull the release lever to the front to close it.
[81]
Attention: Do not pull strongly on the roll media when you align it with the
guideline. The roll media may not feed out straight in some cases.
Raise the upper cover stopper to release the lock then close the upper cover.
15.
[82]
Media Type
HW Coated
The following types of roll media listed below can be loaded on the roll holder. Be
sure to match the roll media with the media type that you want to use. Only the types
34
Chapter 1 Read this first
f
e
Advertisement
Table of Contents
