Oce CS2024 Quick Start Manual page 21

Push the release lever toward the rear, remove the protective sheet (b) on the platen,
3.
then pull the release lever to the front.
[49]
Remove the hex screw from the belt stopper (c) then remove a caution card with a
4.
strings and the belt stopper.
[50]
Note: The belt stopper and hex wrench will be needed again when you move the
printer. Store the removed belt stopper, tools, rail cleaner and belt stopper in a safe
place.
Attention: Always use both hands when you close the upper cover; hold the
upper cover (a) with one and then close the upper cover.
Removing the Packing Material
21