Table of Contents
Advertisement
Hold the roll with the leading edge of the roll media facing the printer as shown in
10.
the illustration, then align the roll core (b) with the left and right slots of the left and
right guides (c) then load carefully.
[77]
Push the release lever toward the rear to open.
11.
[78]
Pull out the leading edge of the roll evenly and insert it into the feed slot (d) and feed
12.
it in until you hear the suction sound of the vacuum.
[79]
When you feed the roll media as far as the platen, you will hear suction on the media
start automatically.
Attention: If media does not feed easily through the feed slot (d) insert the edge
skewed to the left or right corner, and then feed it in until it is parallel.
b
d
c
Loading Roll Media
33
Advertisement
Table of Contents
