No Security - ZyXEL Communications VMG1312-B Series User Manual

Chapter 7 Wireless
Table 15 Network Setting > Wireless > General (continued)
LABEL
Control
Sideband
Passphrase
Type
Passphrase Key
Wireless Network Settings
Wireless
Network Name
(SSID)
Hide SSID
Client Isolation
MBSSID/LAN
Isolation
Enhanced
Multicast
Forwarding
BSSID
Security Level
Security Mode
Apply
Cancel

7.2.1 No Security

Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
108
DESCRIPTION
This is available for some regions when you select a specific channel and set the Bandwidth
field to 40MHz. Set whether the control channel (set in the Channel field) should be in the
Lower or Upper range of channel bands.
If you set security for the wireless LAN and have the Device generate a password, the
setting in this field determines how the Device generates the password.
Select None to set the Device's password generation to not be based on a passphrase.
Select Fixed to use a 16 character passphrase for generating a password.
Select Variable to use a 16 to 63 character passphrase for generating a password.
For a fixed type passphrase enter 16 alphanumeric characters (0-9, A-Z, with no spaces). It
must contain both letters and numbers and is case-sensitive.
For a variable type passphrase enter 16 to 63 alphanumeric characters (0-9, A-Z, with no
spaces). It must contain both letters and numbers and is case-sensitive.
The SSID (Service Set IDentity) identifies the service set with which a wireless device is
associated. Wireless devices associating to the access point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Select this to keep the wireless clients in this SSID from communicating with each other
through the Device.
Select this to keep the wireless clients in this SSID from communicating with clients in other
SSIDs or wired LAN devices through the Device.
Select both Client Isolation and MBSSID/LAN Isolation to allow this SSID's wireless
clients to only connect to the Internet through the Device.
Select this check box to allow the Device to convert wireless multicast traffic into wireless
unicast traffic.
This shows the MAC address of the wireless interface on the Device when wireless LAN is
enabled.
Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the Device. When you select to use a security, additional
options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
VMG1312-B Series User's Guide