ZyXEL Communications VMG1312-B Series User Manual page 90

Chapter 6 Broadband
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 21 Bridge Mode (ADSL/VDSL over PTM)
The following table describes the fields in this screen.
Table 9 Bridge Mode (ADSL/VDSL over PTM)
LABEL
General
Active
Name
Type
Mode
VLAN
Active
802.1p
802.1q
QoS
Rate Limit
Apply
Cancel
90
DESCRIPTION
Select this to activate the WAN configuration settings.
Enter a service name of the connection.
Select ADSL/VDSL over PTM as the interface that you want to configure. The Device uses
the VDSL technology for data transmission over the DSL port.
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
This section is available only when you select ADSL/VDSL over PTM in the Type field.
Select this to add the VLAN Tag (specified below) to the outgoing traffic through this
connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
VMG1312-B Series User's Guide