Table of Contents
Advertisement
Place a sheet of paper into the 2nd Bin of the
7
Staple Sorter.
2nd Bin
Test Print from software application. Then,
8
the Staple Sorter test-staples the paper
several times automatically.
Setup the PDD options Application Menu
print,
click "property",
click "Fiery Options",
click "Finishing",
click Stapler Mode "on".
Remove the sheet of paper from the 2nd Bin
9
and check that it has been stapled.
* If no staples are evident, place another
sheet of paper into the 2nd Bin and repeat
steps 7, 8, and 9.
3. When the Message "NO STAPLE" Appears
NOTES
• Replace the Staple Cartridge only after you are
prompted to do so by the message. Removing
the Staple Cartridge before then will result in
stapling trouble.
• Immediately after the new Staple Cartridge has
been loaded, be sure to test-staple the paper
following steps 7 through 9.
• DO NOT turn the green gear near the
C4119O014AA
Cartridge inside the Staple Unit.
1136O009AA
1144O489AA
6-7
Advertisement
Table of Contents
