Table of Contents
Advertisement
(8) Press the Set key. The first setting item of the selected submenu (Level 3) is displayed. The menu on
Level 4 may be displayed depending on the main menu that is selected ( p. 4-11).
Select the menu in the same manner.
This example describes the condition when the [Ethernet Setup] is selected in the level 3.
TCP/IP Setup
Ethernet Setup
Useful Tip
The [Network Setup] settings are required when the printer is connected to a network. In this case, the
[Protocol Setup] - [TCP/IP Setup] is set directly for this explanation. However, do not actually set only
[Protocol Setup] but set also [Service Setup] and [Port Setup] simultaneously.
(9) Use the M and L keys to select the setting value of the item. (In this example, the setting value is
Yes/No.)
Enable TCP/IP
No
M
Enable TCP/IP
Yes
(10) Press the Set key. The following setting item is displayed.
Enable TCP/IP
Yes
(11) Use the M and L keys to switch the numeric characters when performing the settings. Press the
key to shift the cursor (underlined section) to switch the following numeric characters.
IP Address
127.0.0.1
L
IP Address
128.0.0.1
(12) Set all the numeric characters and press the Set key. The following setting item is displayed.
IP Address
247.123.0.1
(13) Set this item by the same procedure as described in step (11) and press the Set key. This ends the
Ethernet setting and operation shifts to the TCP/IP setup end menu.
Subnet Mask
247.255.123.1
(14) Continue these procedures to set the other items in the TCP/IP Setup menu.
(15) In the Setup menu, set "Save Changes" to "Yes." ( p. 4-10).
Set key
L
Set key
M
key
Set key
Set key
2. Setup Menu Procedures
Enable TCP/IP
No
IP Address
127.0.0.1
IP Address
128.0.0.1
Subnet Mask
225.225.225.0
TCP/IP Setup
Exit
4-7
Advertisement
Table of Contents
