Guard Assembly; Front Handle - Worx WG250 Instructions Manual

SYMBOLS
Warning
Read the manual
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
Always charge battery between 36º
- 95ºF (2º -35ºC)
1-Hour ChargingTime
Use inside only
To avoid possibility of electric
shock, do not use in damp or wet
conditions
Thermal Cutoff will cut off
when the temperature is over
266°F(130°C)
Cordless Hedge trimmer
CTC-WG250-M-060417.indd 9
WARNING! DO NOT USE
THE PRODUCT WITHOUT
ATTACHING THE GUARD AND

FRONT HANDLE.

1.GUARD ASSEMBLY

Insert the guard into the slot as illustrated in
A.1, making sure it is securely attached.
Use two screws to fix the guard securely.(See
A.2).
2. FRONT HANDLE ASSEMBLY
The front handle must be assembled before
use:
a) Make sure the CAM lever is in the closed
position (fig B.1).
b) Attach the handle to the housing, aligning the
mark to housing and handle (fig B.2 Fig B.3).
c) Insert the locking bolt(7) into the handle
(figC.1) and fully tighten the bolt.
d) Check whether handle is firmly secured, if
not retighten the locking bolt.
e) Open the CAM lever (fig C.2) and adjust
handle to the required position and close the
CAM Lever(6).
CHARGING YOUR BATTERY PACK
Warning: The charger and battery pack
are specifically designed to work together
so do not attempt to use any other devices.
Never insert or allow metallic objects into your
charger or battery pack connections because an
electrical failure and hazardous situation will
occur.
3. BEFORE USING YOUR CORDLESS
HEDGE TRIMMER, YOU MUST FULLY
CHARGE THE BATTERY
Your battery pack is UNCHARGED and you
must fully charge once before use.Your battery
pack will not be fully charged until you have
performed several charge and discharge
operations by charging & working with your
hedge trimmer. After this your battery pack
performance will improve.
4. HOW TO CHARGE YOUR BATTERY
PACK
Connect the battery charger to the power sup-
09
ENG
2006-4-20 14:53:29