Setup Diskette For Windows 2000 - IBM T56A Manual

Setup Diskette for Windows 2000

This section must be
completed before
continuing with the
Windows 2000 Auto Setup on
page 8.
i On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends
using either 1024 x 768 at a
refresh rate of 60Hz or 640 x
480 at a refresh rate of 60Hz.
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Monitor Installation diskette.
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows 2000.
4. Open the D P
ISPLAY ROPERTIES
C P and then double clicking on the D
ONTROL ANEL
5. Select the S
ETTINGS
6. Select the A
DVANCED
7. Select the M tab.
ONITOR
8. Select the P
ROPERTIES
9. Select the D tab.
RIVER
10.Open the U D
PGRADE
D and then select the N
RIVER
11.Select the "Display a list of the known drivers for this device so that I can
choose a specific driver" and then select the N
12.Insert the Setup diskette into drive A: and select the H
13.Select OK.
14.Choose IBM T56A monitor and select OK. The files will be copied from
the diskette to your hard drive.
15.Close all open windows and remove the diskette.
16.Reboot the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
window by clicking on S
tab.
button.
button.
D W window by clicking on U
EVICE RIVER IZARD
button.
EXT
, S ,
TART ETTINGS
icon.
ISPLAY
PDATE
button.
EXT
D button.
AVE ISK
7