Table of Contents
Advertisement
T84H_setup0915_final.fm Page 8 Monday, September 25, 2000 7:40 PM
Setup Diskette for Windows 2000
This section must be
completed before
continuing with the
Windows 2000 confguring
for your monitor on page 10.
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality. IBM recommends using
either 1280 x 1024 at a refresh
rate of 60Hz.
8
To use the Plug and Play feature in Windows 2000, files should be loaded
from the IBM Flat Panel Monitor Installation diskette.
1.
Turn off the computer and all attached devices.
2.
Ensure that the monitor is connected correctly.
3.
Turn on the monitor and then the system unit. Allow the system to boot
into Windows 2000.
4.
Open the
D
PROPERTIES
ISPLAY
and then double clicking on the
C
P
ONTROL
ANEL
5.
Select the
tab.
S
ETTINGS
6.
Select the
A
DVANCED
7.
Select the
tab.
M
ONITOR
8.
Select the
P
ROPERTIFS
9.
Select the Driver tab.
10. Open theUpgrade Device Driver Wizard window by clicking on UPDATE
DRIVER and then select the NEXT button.
11. select the "Display a list of the known dirvers for this device so that lcan
choose a specifc driver" and then sefect the NEXT button.
12. Inset the Setup diskette into drive A: and select the HAVE DISK button.
13. select OK.
14. Choose
monitor and select
IBM T750
the diskette to your hard drive.
15. Close all open windows and remove the diskette.
16. Reboot the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
window by clicking on
button.
button.
. The files will be copied from
OK
,
,
S
S
TART
ETTINGS
icon.
D
ISPLAY
Advertisement
Table of Contents
