IBM T56A Manual page 30

2. Lift the bottom of the cable cover (A) and pull it off.
A
C
3. Lay the monitor facedown on a cushion and remove the four screws
holding the hinge mechanism on the monitor. Lift off the hinge and base
assembly(B).
4. If you are installing an arm or wall-mounting device, follow the directions
included with the device. If you are just changing your cables, continue
with step 5.
5. Squeeze the side of the rear cover (C) and pull it off.
6. Remove the signal cable and the power cord from the monitor by
disconnecting the corresponding adapters.
7. Connect the signal cable and the power cord and ensure the positioning
of the cables is as shown in the diagram.
[This ensures ease of rotation.]
8. Slide the rear cover(C) on rear panel of the monitor.
9. Put the hinge cover back on, fit the four screws to hold the hinge
mechanism on rear panel of the monitor.
10. Slide the cable cover on the base assembly(B).
To obtain the correct cables and/or to get further instructions on
installing them, call the IBM HELPCENTER at the above numbers or
contact your dealer, retailer, or other IBM authorized Servicer.
B
23