Table of Contents
Advertisement
Auto Setup
Auto Setup
Before carrying out this
section, it is very important
that The Setup Diskette for
Windows 95 or Windows 98
has been run.(see page6)
i
The Setup Utility included
on the setup diskette is for
displaying dot patterns. They
do not replace or modify the
display driver.
i
The Auto Setup
instructions require the
monitor to be warmed up for 15
minutes. This is not required
for normal operation.
i
By pressing the
and
keys simultaneously allows
direct access to the auto set-up
controls.
i
If your PC does not run
with the setup diskettes
shipped with the monitor, refer
to Manual Setup on page 12
i
The AUTO SETUP process
only applies to the current
screen mode. When a new
mode is selected, repeat this
section to reset the monitor.
8
When you first use your monitor you must perform Auto Setup. This procedure
sets up your monitor to process the video signals from your computer without
image discoloration or smearing. After you perform Auto Setup, the settings are
stored and used each time you turn on the monitor.
In order to optimise the displayed image a set-up utility is provided on the
IBM Monitor Installation Diskette. Operation of this utility is dependent on the
operating system on your PC. For correct operation locate the operating system
on your PC from the table below and follow the appropriate instructions. You
may choose to run AUTO SETUP for each operating system that you use. This
means that if you sometimes use your monitor while running any version of
Windows and sometimes also use it from within DOS (not a DOS window), you
must run AUTO SETUP for both Windows and DOS. You may run versions of
AUTO SETUP in any order.
Operating System
DOS
Windows 3.1
Windows 95
Windows 98
Window 2000
Window NT
Before you begin AUTO SETUP for your PC:
1. Make a backup copy of the setup diskettes supplied with the monitor.
2. Make sure the PC's video mode is set in the range of the supported
screen resolution shown in the table on page18.
You should perform AUTO SETUP for each screen mode you use.
Corresponding Auto Setup procedure
Auto Setup for DOS on page 9
Auto Setup for Windows 3.1,Windows 95,
Windows 98, Windows 2000 or
Windows NT on page 10
Advertisement
Table of Contents
