Mark Levinson 31 Manual page 39

Adding a selection
to a program
Temporarily overriding a
previously saved program
Erasing a program
You also may add a selection to the end of a previously saved
program. To add a selection:
1. Load a CD for which you've already saved a program (the letter P
will appear preceding the track number on the Display); or load
an unprogrammed CD, then assemble and save a program.
2. Using the Next and Previous (or the numbered buttons on the
Remote Control), select the track you want to add to your
program.
You may also include indexes in your program. Press index mode,
then use Next and Previous (or the numbered buttons on the
Remote Control) to select an index.
Note: If your Nº31 is linked to a compatible Mark Levinson
digital processor via the communication ports, you may set
the playback polarity independently for each track. (See
"Linked functions.")
Before continuing to step 3, press the polarity invert button on
the digital processor's front panel, or press d/a polarity on the
Nº31's Remote Control.
3. Add the selection to your program by pressing program
Remote Control, press prg/time, then press
Note: You must press program
five seconds after making a selection, or the selection won't
be recorded.
4. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press program
each selection.
5. When you've finished adding selections, press program save; the
Display will show PROG CHANGED.
To override a previously saved program (temporarily), press
program clear (on the Remote Control, press the 0 numbered key,
then press prg/time); the Display will show PROG CLEARED.
All of the CD's tracks will be accessible for basic operation, but the
program will still be retained in the Nº31's memory. (See "Basic
operation.")
Note: If you press program save after pressing program clear,
the Display will show PROG DELETED and the program will be
erased from the Nº31's memory.
To erase a previously saved program permanently from the Nº31's
memory:
1. Press program clear; the Display will show PROG CLEARED.
2. Press program save; the Display will show PROG DELETED.
+
).
+ +
(or prg/time and ) within
+
(or prg/time and
+
(on the
+
) after
39