Mark Levinson 31 Manual page 33

Using indexes
Beginning play in the
middle of a track
The Pause function
Repeating the entire CD
Repeating the
current track
If a CD has indexes, you may use them to begin play in the middle of
a track.
1. Press index mode. (If there was no CD in play, the Display will
show INDEX SEARCH.) In a few seconds, the LED above the button
will flash.
2. Using Next and Previous (or the numbered buttons on the Remote
Control), select an index.
3. Press Play to begin play at the index you selected.
You may use prg/time on the Remote Control to begin play at a
specific time — whether or not it corresponds to an index.
1. Using Next and Previous (or the numbered buttons on the Remote
Control), select a track.
2. Press prg/time, then press the numbered buttons corresponding to
when you'd like play to begin. (The numbers you select will
appear in the time part of the Display.)
3. To begin play at that point, press Play.
Note: The time you select depends on the selection you've
made with the display mode button: elapsed or remaining,
CD or track.
For example, if you want to begin play one minute and thirty
seconds into track 2, first press display mode until the elapsed
time and on track LEDs light. Then select track 2 by pressing
Next or Previous (or by entering 02). Press prg/time, enter 130,
then press Play.
To suspend play while a CD is playing, press Pause. To resume play at
the same point, press Pause again.
If left in Pause for several minutes, the transport will stop spinning and
the laser will turn off (thereby enhancing the longevity of both). This will
be indicated by the Pause indicator in the display ("yy") flashing on
and off. Alternatively, this Long Term Pause feature may be engaged
by pressing and holding the Pause button until the indicator begins to
flash in the display. Pressing Pause again will resume play at the point
where Pause was first pressed, (after a short delay to allow the disc to
get up to speed).
To "cue up" the beginning of a CD or track, press Pause before
pressing Play (5). To begin play, press Pause again. (You may also
select another track or index while play is suspended.)
To repeat (continuously) all tracks on a CD, press repeat disc. While
the repeat disc function is active, the LED above the button is lighted.
To return to normal play, press repeat disc again.
To repeat (continuously) the track in play, press repeat track. While the
repeat track function is active, the LED above the button is lighted. To
return to normal play, press repeat track again.
33