Mark Levinson 31 Manual page 28

Levelling the
transport assembly
28
13. Press the LID Open/Close button on the top panel.
For the best performance, the Nº31's transport assembly should be
level. Four levelling screws (one inside each finger well) allow you
to adjust this.
With the supplied 3/32" hex driver, and using the Nº31's bubble
level as a gauge, adjust one or more of these screws to bring the
transport assembly to level. To lower a corner, turn the
corresponding screw clockwise; to raise a corner, turn the screw
counterclockwise.
Levelling
screws
14. Place the Disc Damper on the spindle, then press LID Open/Close
again to close the LID.
Bubble level Levelling
screws