Rear Panel - Mark Levinson 31 Manual

main power
2 3 4
PRECAUTION
PRECAUTION
PRECAUTION
18
REFERENCE CD TRANSPORT Nº 31
designed and manufactured in U.S.A.
by MADRIGAL
communication ports
slave slave eiaj
out in
5 6 7

Rear panel

Disconnect all associated equipment from the AC mains BEFORE
making any signal connections and applying power to the Nº31.
1 Operating voltage indication
The Nº31 is set internally for 100, 120, 200, 220, or 240VAC mains
operation @ 50 or 60Hz. Make sure that this label indicates the
correct AC operating voltage for your location. (See "Set-up and
installation").
2 main power
This switch turns the Nº31 on and off. The switch must be in the "|"
(on) position for the Nº31 to function. (See "Set-up and
installation.")
Never operate the main power switch without first making
sure that power is turned off to your receiver, integrated
amplifier, or preamplifier/power amplifier.
3 AC power cord socket
This socket accepts AC mains power via the supplied AC power
cord.
4 Fuse compartment
The panel surrounding the main power switch is also a hinged
cover for the Nº31's fuse compartment. The Nº31 uses two 1.0-
ampere slow-blow fuses.
Never open the fuse compartment without first disconnecting
the Nº31 from AC power. If you need to replace the fuses,
always use the same type of fuse.
To open the fuse compartment, insert the tip of a small, flat-bladed
screwdriver into the slot at the top edge of this panel. Gently pry
open the top edge of the compartment cover.
S/N
digital outputs
aes/ebu
st spdif
8
9 10
operating voltage, 50-60Hz:
90 - 110VAC~
105 - 125VAC~
180 - 220VAC~
210 - 240VAC~
230 - 250VAC~
WA R N I N G : B E F O R E AT T E M P T I N G TO
OPERATE THIS DEVICE, REFER TO OWNER'S
M A N U A L F O R P R O P E R O P E R AT I N G
INSTRUCTIONS AND SAFETY PRECAUTIONS.
HAZARDOUS VOLTAGE AVAILABLE INSIDE;
DISCONNECT AC ~ MAINS CABLE BEFORE
OPENING UNIT.
1