Cd Transport Assembly - Mark Levinson 31 Manual

10
1 2

CD transport assembly

1 Finger wells
These cutouts make it easy to grasp a CD by its edges when
placing it on or removing it from the spindle.
Levelling screws
For the best performance, the Nº31's transport assembly should be
level. Four levelling screws (one inside each finger well) allow you
to adjust the transport assembly.
With the supplied 3/32" hex driver, and using the Nº31's bubble
level (3) as a gauge, adjust one or more of these screws to bring
the transport assembly to level. To lower a corner, turn the
corresponding screw clockwise; to raise a corner, turn the screw
counterclockwise.
2 Spindle
This is the device that spins the CD, and on which the CD rests
during play. The CD must be centered on the spindle, and it must
be clamped to the spindle by the Disc Damper.
3 Bubble level
Use this bubble level, along with the four levelling screws (1), to
make sure that the Nº31's transport assembly is level.
3 4 1