Mark Levinson 31 Manual page 37

Assembling a
new program
Shortcut: Ignoring tracks
To assemble a new program:
1. Load a CD, close the LID, and wait for the Display to show the
number of tracks and their total playing time.
2. Using the Next and Previous (or the numbered buttons on the
Remote Control), select the first track in your program.
You may also include indexes in your program. Press index mode,
then use Next and Previous (or the numbered buttons on the
Remote Control) to select an index.
Note: If your Nº31 is linked to a compatible Mark Levinson
digital processor via the communication ports, you may set
the playback polarity independently for each track. (See
"Linked functions.") Before continuing to step 3, press the
polarity invert button on the digital processor's front panel, or
press d/a polarity on the Nº31's Remote Control.
3. Add the first selection to your program by pressing program
the Remote Control, press prg/time, then press
appear preceding the track number on the Display, along with
PRG +.
Note: You must press program
making a selection, or the selection won't be recorded.
4. Assemble the rest of your program (up to 99 selections) by
repeating steps 2 and 3. Make sure to press program
+
prg/time and ) after each selection.
5. When you've finished adding selections:
a. If you want to play your program without recording it in the
Nº31's memory, go on to step 6.
b. If you want to record your program in the Nº31's memory, press
program save; the Display will show NEW PROGRAM.
6. To play the program, press Play.
If you want to play most of a CD, and just "ignore" a few tracks, you
may want to use this shortcut:
1. Load a CD, close the LID, and wait for the Display to show the
number of tracks and their total playing time. (See "Basic
operation.")
2. Using the Next and Previous (or the numbered buttons on the
Remote Control), select the first track you want to eliminate from
your program.
3. "Ignore" the track by pressing program
press prg/time, then press
the track number on the Display, along with PRG –.
4. Repeat steps 2 and 3 for each track you want to ignore, making
sure to press program
+
within five seconds after
–
(on the Remote Control,
–
). The letter P will appear preceding
– –
(or prg/time and ) each time.
+
(on
+
). The letter P will
+
(or
37