Table of Contents
Advertisement
46
en | Configuration
Click Set to apply the changes.
5.7.3
Advanced
RTSP
RTSP port
If necessary, select a different port for the exchange of the RTSP data from the list. The
standard RTSP port is 554. Select Off to deactivate the RTSP function.
802.1x
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication
must be activated here to allow communication with the unit. The RADIUS server must also
contain the corresponding data.
To configure the unit, you must connect the camera directly to a computer using a network
cable. This is because communication via the network is not enabled until the Identity and
Password parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the camera.
Password [EAP-MD5]
Enter the password that is stored in the RADIUS server.
Certificates [EAP-TLS]
If any certificates are already uploaded at the client level or at the server level, they show
here.
Click Configure to be redirected to the Certificates page in order to add or configure any
existing certificates.
TCP metadata input
TCP port
The device can receive data from an external TCP sender, for example an ATM or POS
device, and store it as metadata. Select the port for TCP communication. Select Off to
deactivate the function.
Sender IP address
Enter a valid Sender IP address.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol: UDP, TCP, or TLS.
Click Set to apply the changes.
2023-11 | V01 | F.01U.408.367
User manual
FLEXIDOME micro 3100i
Bosch Security Systems B.V.
Advertisement
Table of Contents
