Package Contents; Installing The Media Converter; Standalone Installation; 12 V Dc Connector On Rear Panel - Allied Telesis AT-MC101XL Installation Manual

Package Contents

Make sure the media converter package contains the following items:
AT-MC101XL, AT-MC102XL, AT-MC103XL, or AT-MC103LH Fast
Ethernet Media Converter
Four Protective Feet (for standalone use only)
External AC-DC Power Adapter
This Installation Guide
Contact your sales representative if any items are missing or damaged.

Installing the Media Converter

Read the warnings below before beginning any installation.
Do not stare into the laser beam when installing the media converters.
! !
! !
5
LIGHTNING DANGER: DO NOT WORK on equipment or CABLES
during periods of LIGHTNING ACTIVITY
DO NOT BLOCK AIR VENTS
The following steps are for a standalone installation. To install media
converters in a rack mount chassis, see "Rack mount Chassis Installation" on
page 7. For information concerning back-to-back converter configuration, see
"Back-to-Back Installation" on page 7.

Standalone Installation

1. Remove all equipment from the package and store the packaging in a safe
place
2. Attach the four rubber feet to the base of the unit, placing one rubber foot
in each corner. For rack-mount installation, do not attach the four rubber
feet.
3. Plug the AC-DC power adapter into an appropriate AC power outlet and
insert the power plug into the DC receptacle located on the rear panel.
Warning
! !
! !
7
12 V D C
Figure 6 12 V DC Connector on Rear Panel
! !
! !
6
Installation Guide
5