Setting Dynamic Route Seek; Setting The Rds-Tmc Voice Guidance To Interrupt The Radio Or Cd, Etc; Selecting Tmc Reception (Only When Tmc-001P Is Connected) - Alpine NVD-T334 Owner's Manual

TMC Operation
OK

Setting Dynamic Route Seek

1
In RDS-TMC Information Menu, move the Flipper
switch up or down to select "Dynamic Navigation."
Press the OK button or MODE knob to execute the
selection.
2
The display changes to "Dynamic Navigation" setting.
Move the Flipper switch up or down to select "On" or "Off."
Press the OK button or MODE knob to execute the
selection.
3
When you set to "On", a message regarding an
evasion route is displayed while guiding the current
route.
Move the Flipper switch up and down to select "OK"
then press the OK button or MODE knob to execute
the selection. The unit seeks for a route in
consideration of the traffic event given through the
RDS-TMC information and new guidance will be given.
a
c
a : The representative RDS-TMC icon for traffic
event information which is currently being given
on the route is displayed.
b : A message regarding an alternative route (s) is
displayed.
c : The difference in distance between a route you
have already set and a new route (evasion route)
is displayed.
"----" is displayed if the distance cannot be
calculated.
d : If you want to change the guidance for a new
route, select "OK." If not, select "Cancel."
Note
When you set to OFF, the unit performs an initial seek for a
route without consideration for any traffic event given through
the RDS-TMC.
24
-EN
Flipper switch
MODE
Setting the RDS-TMC Voice Guidance
to Interrupt the Radio or CD, etc.
1
In the RDS-TMC Information menu, move the Flipper
switch up and down to select "Guide."
Press the OK button or MODE knob to execute the
selection.
2
The display changes to the "Guide" setting display. Move
the Flipper switch up or down to select "On" or "Off."
On : TMC voice guidance will activate
Off : No TMC voice guidance
3
Press the OK button or MODE knob to execute the
selection.
Selecting TMC Reception (Only when
TMC-001P is connected)
If the optional RDS-TMC receiver box TMC-001P is
connected, reception of TMC can be set for either
"Country" or "Station."
1
In RDS-TMC information Menu, move the Flipper
switch up and down to select "Set up RDS-TMC."
Press the OK button to execute the selection.
2
The display changes to "Set up RDS-TMC."
Move the Flipper switch up and down to select
"Country" or "Station."
Press the OK button or MODE knob to execute the
selection.
b
d
3
Move the Flipper switch to select the name of the
country or station you selected in step 2.
Press the OK button or MODE knob to execute the
selection.
If you select "Auto," a country and a station will be
selected and received automatically.
Note
If you select stations or countries listed as receivable in the list
while you are in the area where these stations are not receivable,
the TMC receiving is not functioned.