Adding Waypoints On The Route; Setting The Display For The Destination Time - Alpine NVD-T334 Owner's Manual

Adding Waypoints on the Route

You can set up to 2 waypoints after the route search
from your current location to your destination has been
completed.
1
Find the waypoint by address, Local POIs, etc.
2
Select "Add Way Point" and press the OK button or
MODE knob to execute the selection.
3
The displayed screen changes and the added
waypoints are displayed.
Press the OK button or MODE knob to set the added
waypoints.
The route searching starts.
Note
Before setting the point, you can move the location of the added
waypoint by moving the cursor with the Flipper switch.
Tips
• After setting the waypoint, each time you move the Flipper
switch up, the direction and distance to the waypoint, and
the anticipated required time that you have set is displayed.
(The required time is only displayed when you are driving
with the route guidance.)
• If "Arrival" is set in the "Setting the Display for the
Destination Time" section (this page), the anticipated
arrival time is displayed.
Setting the Display for the
Destination Time
You can set the display for the destination time in order
to anticipate your arrival time or estimated remaining
time before arrival.
1
Press the MENU button to display "NAV. MENU."
2
Select "Navigation Setup" from "NAV. MENU" by
moving the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
3
Select "System Setup" from the "Navigation Setup"
menu by moving the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
4
Select "Est. Time to Dest." from the "System Setup"
menu and press the OK button or MODE knob to
execute the selection.
5
The displayed screen changes to the "Est. Time to
Dest." menu. Select "Arrival" or "Remaining" from the
menu and press the OK button or MODE knob to
execute the selection.
Arrival : the anticipated arrival time will be set, and
the indicator is shown in the
guidance display.
Remaining : the estimated remaining time will be set,
and the
guidance display.
6
To return to the previous screen, press the RTN button.
To return to the "NAV. MENU" screen, press the MENU
button.
indicator is displayed on the
17
-EN