If This Message Appears - Alpine NVD-T003 Owner's Manual

Reference

If this Message Appears

Various messages are displayed on the monitor screen during operation. In addition to the messages telling you the current
status or providing guidance for the next operation, there are also the following error messages. If one of these error
messages is displayed, carefully follow the instructions in the solution column.
Message
E001
E002
No data
Not Registered
Waypoints are full.
Memory points are
full.
Specify the
destination before
using this function.
Use after setting the
waypoint.
Route could not be
found.
Destination is _ m
from the current
position or
Destination nearby
within _ m
Destination too far.
Please choose a
destination within
5000 km distance
No registered roads
nearby
30
-EN
Cause
• A disc that the system cannot read
has been loaded.
• Main unit error
• When there is no item in the list
when searching for the destination,
the display shows "No data."
• An attempt was made to search
home with no home registered.
• An attempt was made to search a
memory point with no memory
registered.
• An attempt was made to set more
than 2 waypoints.
• An attempt was made to register
more than 50 points in memory.
• An attempt was made to search
the destination from the departure
point with no destination
registered.
• An attempt was made to erase a
waypoint even though no waypoint
is set.
• No route could be found, for
example due to traffic situations.
• When the distance from the
departure point to the destination
is too close, this message appears.
• When the distance from the
departure point to the destination
is too far, this message appears.
• The current vehicle position cannot
receive the GPS signals.
• There is no road in the vicinity of
the current vehicle position where
GPS signals can be received.
Solution
Insert a navigation disc designed only for this system.
Please consult your Alpine dealer.
Set by selecting another searching method.
Register your home or a memory point, then execute
the search.
Erase unnecessary waypoints, then set again.
Erase unnecessary points, then register.
Specify the destination, then carry out the search.
This message simply announces that no waypoint is
set. The message goes out soon.
Move to another location. Set the route search again.
Because the distance to the destination is too close,
searching for the route cannot be carried out. Drive on
the road by complying the traffic regulations.
Your destination must be within 5,000 km.
Move to another location, then resume the route
search.