Deleting Waypoints On The Route; Drive Simulation - Alpine NVD-T003 Owner's Manual

Deleting Waypoints on the Route

If you want to delete all waypoints, perform following
operation.
1
Press the MENU button to display "NAV.MENU."
2
Select "Edit Route" from "NAV.MENU" by moving the
Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
3
Select "Edit Way Points" from the "Edit Route" menu by
moving the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
4
Select "Delete" from the "Edit Way Points" menu and
press the OK button or MODE knob to execute the
selection.
• When you want to erase all points, select "Delete All"
and press the OK button or MODE knob to execute
the selection.
When the confirmation message appears, select
"Yes" and press the OK button to execute the
selection.
5
The displayed screen changes. Move the cursor to your
desired waypoint to delete and press the OK button or
MODE knob.
When the confirmation message appears, select "Yes"
and press the OK button or MODE knob to execute the
selection. Its waypoints are deleted.

Drive Simulation

You can check the searched route by carrying out the
drive simulation.
1
After searching the route, press the MENU button to
display "NAV.MENU."
2
Select "Edit Route" from "NAV.MENU" by moving the
Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
3
Select "Demo" from the "Edit Route" menu by moving
the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
4
The drive simulation starts.
To exit the drive simulation, press the RTN button.
19
-EN