Registering Your Home - Alpine NVD-T003 Owner's Manual

5
Select the desired language from the "Language" list
by moving the Flipper switch up or down and press
the OK button or MODE knob to execute the selection.
Note
For English, you can select the distance indications in either
miles or Kilometres (km).
For other languages, only kilometres are used for the distance
indications.
6
The selected language is displayed.
An important message is displayed. Please read this
message after stopping the vehicle in a safe location.
Press the OK button. (You cannot carry out this
operation with the Enter button on the optional remote
control.)
Note
You cannot use the MENU button while the vehicle is in motion.
Stop your vehicle in a safe place before using the MENU button.

Registering Your Home

If home has already been registered, you can call it up
with a simple operation.
1
Park your vehicle near your home where GPS signal
reception is good.
2
Start your vehicle engine and set to navigation mode,
then wait about 5 minutes to receive clear GPS signals.
3
Press the OK button.
The message appears. Select "Yes" by the Flipper
switch and press the OK button or MODE knob to
execute the selection.
4
Press the MENU button to display "NAV. MENU."
5
Select "NAVI Setup" from "NAV. MENU" by moving the
Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
6
Select "Memory Points" from "NAVI Setup" by moving
the Flipper switch up or down and press the OK
button or MODE knob to execute the selection.
7
The screen changes and the address stored in step 3
is displayed.
Press the OK button or the MODE knob to set the
address.
8
The screen switches to the "Edit Memory Point" menu.
Move the Flipper switch up or down to select
"Register Home."
Press the OK button or MODE knob to execute the
selection.
9
The message is displayed.
Select "Yes" by the Flipper switch and press the OK
button or MODE knob to execute the selection.
Your home is registered.
10
To return to the previous screen, press the RTN button,
or to return to the "NAV. MENU" screen, press the
MENU button.
11
-EN