Displaying The Traffic Event Information On Route; Displaying All Receiving Traffic Event Information - Alpine NVD-T003 Owner's Manual

TMC Operation
OK
MENU
Displaying the Traffic Event
Information on Route
1
After setting the route, press the MENU button to
display "NAV.MENU."
2
Select "RDS-TMC Information" from "NAV. MENU" by
moving the Flipper switch up or down.
Press the OK button or MODE knob to execute the
selection.
3
Select "Traffic On Route" from the "RDS-TMC
Information" menu by moving the Flipper switch up or
down.
Press the OK button or MODE knob to execute the
selection.
22
-EN
Flipper switch
MODE
4
If there is any traffic event information on your set
route, the information will be displayed.
When there are more than one piece of information,
move the Flipper switch up or down to select the
further information you want to know.
Press the OK button or MODE knob to execute the
selection.
a
b
c
a : Road name
b : Destination place name of TMC event
c : Starting place name of TMC event
d : When this mark is displayed, "Detail Information"
in step 5 will be displayed.
Note
If the destination or starting place name is long, the whole name
may not be displayed. It is not a malfunction.
5
Any further information is displayed.
When there are more than one pieces of the traffic
event information, move the Flipper switch up or down
to switch the further information you want to know.
Note
If there is no information on your set route, all other receiving
information is displayed.
Tip
While receiving the TMC and displaying your car's
position, press the OK button for more than two seconds to
display the traffic event information on your set route. If
there is no information on your set route, all other receiving
information is displayed.
Displaying all Receiving Traffic event
Information
1
In RDS-TMC Information Menu, move the Flipper
switch up or down to select "All Traffic Conditions."
Press the OK button or MODE knob to execute the
selection.
2
The display changes to "All Traffic Conditions" list.
Move the Flipper switch up or down to select the
traffic event information you want to know.
Press the OK button or MODE knob to execute the
selection.
d