Setting the Downmix Mode
This function applies to Dolby Digital, DTS stream sound.
Setting item: DOWNMIX MODE
Setting contents: SURROUND/STEREO
SURROUND: Surround compatible Downmix
STEREO:
Stereo Downmix
Setting the TV Screen Setting
Use the procedure described below to modify the output screen
according to the type of TV monitor (rear monitor) being used.
This setting can also be applied for the IVA-D310R/IVA-D310RB.
If the rear monitor is not connected, the screen setting is 16:9.
Setting item: TV SCREEN
Setting contents: 4:3 LB / 4:3 PS / 16:9
• For some discs, the picture may not be set to the selected screen size.
(For details, refer to the explanation on the disc's jacket.)
4:3 LETTER BOX:
Select this when connected to a conventional 4:3 size (normal
TV aspect ratio) monitor. There may be black stripes visible at
the top and bottom of the screen (when playing a 16 : 9 size
movie). The width of these stripes will depend upon the original
aspect ratio of the theatrical release of the movie.
4:3 PAN-SCAN:
Select this when connected to a conventional 4:3 size monitor.
The picture will fill the entire TV screen. However, due to the
mismatch in aspect ratio, parts of the movie at the extreme left
and right sides will not be visible (when playing a 16 : 9 size
movie).
16:9 WIDE:
Select this when connected to a wide screen TV. This is the
factory setting.
32
-EN
GENERAL Setup
General Setup Operation
The Parking Brake must be engaged to access the DVD mode
screen. Attempting to access this screen while driving will display
the warning-CAN'T OPERATE WHILE DRIVING.
The following steps 1 to 5 are common operations to each
"Setting item" of GENERAL Setup. Refer to each section for
details.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [OTHER SETUP].
The OTHER SETUP screen appears.
3
Touch [
] of GENERAL SETUP.
The GENERAL setup screen appears.
4
Touch [OFF], [ON] or [ ], [ ], etc., of the desired
item to change its setting.
Setting items:
CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME /
DEMONSTRATION / BEEP / AUTO SCROLL / RDS CLOCK
DISP / FM LEVEL / FM CONDITION / PI SEEK /
RDS REGIONAL / PTY LANGUAGE / PLAY MODE / LED
DIMMER LEVEL
5
Touch [RETURN] to return to the previous screen.
Touch [CONTROL] to return to the main source screen that
was displayed before the setup operation was started.
• Immediately after changing the settings of General Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF.
Otherwise, the settings may not be changed.
Displaying the Time
The clock indication on the monitor display is turned on or off
respectively.
Setting item: CLOCK
Setting content: OFF / ON
Setting the Time
Setting item: CLOCK ADJUST
Further setting items : HOUR / MINUTE / TIME ADJUST
Setting content: 0-23 / 0-59 / RESET
HOUR:
Adjust the hour.
MINUTE: Adjust the minute.
RESET:
If the clock shows less than 30 minutes past, the
minute will be ": 00"; more than 30, the hour
advances.
• The clock-adjusting mode is canceled when the power is turned off,
when [RETURN] or [CONTROL] is touched.
• If this setting is carried out, it is also applied for the clock in the
subdisplay displayed.