Switching The Visual Source Only (Simultaneous Function); Cancelling The Simultaneous Function; Blackout Mode On And Off; Setting Visualizer - Alpine IVA-D310RB Owner's Manual

In Mode 3 (Normal), the monitor displays a normal picture at the
centre of the screen with a vertical black band at each side.
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
1
Touch [VISUAL] on the audio source screen.
The VISUAL selection screen appears.
2
Touch a desired visual source.
The visual source is switched to the selected one.

Cancelling the Simultaneous Function

1
Touch the visual screen to display the main control.
2
Touch [CONTROL].
3
Touch [VISUAL] within 5 seconds.
The VISUAL selection screen appears.
4
Touch [NORMAL].
The simultaneous function is cancelled.
• To make the setting, set to "Setting the VISUAL Touch Button" (page
36).
• If a DVD player is connected, you can receive the DVD picture/
sound.
DVD player (DVA-5205P) or DVD changer (DHA-S680P) is
connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture and
sound of the DVD will be output.
The DVA-5210 is connected:
Press V.OUT on the remote control (included with the DVA-5210) to
output DVD picture/sound.
• The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in "Setting the VISUAL Touch Button" (page 36),
only the navigation screen can be recalled.

Blackout Mode On and Off

When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
2
Touch [OFF].
The backlit-display portion goes out.
3
Touch [OFF] again to cancel the display backlight.
• To make the setting, set to "Setting the VISUAL Touch Button" (page
36).
• If any button on the unit is pressed during Blackout mode, the
function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.

Setting VISUALIZER

This setting is available when the expansion box (VPE-S431) is
connected.
1
Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
2
Touch [VISUALIZER].
The Visualizer setting screen is displayed. If you do not
touch any button for 5 seconds, the operating display
buttons, [CONTROL] etc., will disappear.
3
Touch the screen (visual screen only) after the
operating display has disappeared.
The VISUALIZER setup mode is displayed.
4
Set ON/OFF by touching [ON] or [OFF] of
VISUALIZER within 5 seconds.
MODE1 to
MODE6 / OFF: Recalls the maker's setting mode on the
expansion box (VPE-S431).
SCAN: Displays the pattern of MODE1 to MODE6
repeatedly.
Cancelling the Visualizer Function:
Touch [NORMAL] on the VISUAL selection screen.
• To make the setting, set to "Setting the VISUAL Touch Button" (page
36).
• This setting is enabled when OFF is selected for "Setting the Visual
Effect" (page 27) and ON is selected for, "Setting the VISUALIZER
Mode Display" (page 35).

Setting the Visual Effect

This setting becomes available when the expansion box (VPE-S431) is
connected.
1
Touch [VISUAL] on the visual main source screen.
The VISUAL selection screen is displayed.
2
Touch [VISUALIZER].
The Visualizer setting screen is displayed. If you do not
touch any button for 5 seconds, the operating display
buttons, [CONTROL] etc., will disappear.
3
Touch the screen (visual screen only) after the
operation display has disappeared.
The VISUALIZER setup screen appears.
27
-EN