Chapter 2 — Connecting and Configuring the SR30
Serial Parameter Bar Codes
If your SR30 is connected to a host with an RS-232 cable,
configure your SR30 serial parameters to match the host device.
This section contains bar codes for basic serial parameters. To
configure additional serial parameters, see EasySet version
5.6.0.0 or later.
Note: By default, RTS/CTS hardware protocol is disabled. To
enable this parameter, use EasySet version 5.6.0.0 or later. RTS/
CTS hardware protocol operates only in one direction. The
SR30 requests permission from the host to transmit and
monitors host transmissions.
* = default
Baud Rate
1200
4800
19200*
57600
14
SR30 Handheld Scanner User's Guide
2400
9600
38400