Serial Parameter Bar Codes - Intermec SR30 User Manual

Japanese Windows

Serial Parameter Bar Codes

If your SR30 is connected to a host with an RS-232 cable,
configure your SR30 serial parameters to match the host device.
This section contains bar codes for basic serial parameters. To
configure additional serial parameters, see EasySet version 5.4.4.0
or later.
Note: By default, RTS/CTS hardware protocol is
disabled. To enable this parameter, use EasySet version
5.4.4.0 or later. RTS/CTS hardware protocol operates
only in one direction. The SR30 requests permission
from the host to transmit and monitors host
transmissions.
* = default
Baud Rate
1200
4800
SR30 Handheld Scanner User's Guide
Chapter 2 — Connecting and Configuring the SR30
IBM/NCR Terminals
2400
9600
11