Table of Contents
Advertisement
5. Operation
5.6 Display Setting Screen (main)
This screen is used to make the input signal display aspect ratio, horizontal and vertical
display positions and sizes, and other settings.
Screen display
Status
User
Display
A spect
Over Scan
H.Position
V.Position
H.Size
V.Size
Clock
Phase
A UTO
UNDO
IN1: CH name - Signal name
IN2: CH name - Signal name
Display setting screen description (main)
• Aspect:
Clear. The switchable types depend on the type of input signal.
• Over Scan:
Used to select the display size with an overscan of 10% or 20%.
• H/V. Position: Used to adjust the horizontal and vertical positions onscreen.
Move toward the plus side to shift the screen to top right.
Move toward the minus side to shift the screen to bottom left.
• H/V. Size:
Used to adjust the horizontal and vertical sizes onscreen.
Move toward the plus side to enlarge the display size.
Move toward the minus side to reduce the display size.
• Clock:
Adjusts the number of sampled dots for analog signals other than
VIDEO/S-VIDEO and DVI signals.
Increase the setting to get the sampling frequency higher. Decrease
it to get the sampling frequency lower.
Make this adjustment if vertical stripes or noises occur.
Image
Color
Memory
Normal
OFF
0
0
0
0
50
A uto
Cancel
Switch behavior description
Used to switch the video signal aspect ratio from Normal, Full and
Normal
NTSC/PA L
1440 1080 display
Black zones on
both sides
HD
1920 1080 display
14
P-Pre
Normal/Full/Clear
OFF/10%/20%
-200 - + 200
-200 - + 200
-200 - + 200
-200 - + 200
0 - 100
A uto/1-48
Cancel/A DJ
Full
Clear
1920 1080 display
720 540 display
Cut of f at top
and bottom
1920 1080 display
1920 1080 display
Advertisement
Table of Contents
