Assembly - Healthrider H145t Treadmill Manual

ASSEMBLY

•• Assembly requires two persons.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
1. Make sure that the power cord is unplugged.
Attach the Right Wheel Cap (90) to the Base
(94) with two #8 x 3/4" Screws (2).
Attach the Left Wheel Cap (not shown) to the
Base (94) in the same way.
Cut the shipping tie holding the Upright Wire (79)
to the Base (94).
•• To identify small parts, see page 6.
•• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
To avoid damaging parts, do not use power tools.
1
90
2
94
7
79
Tie