2. Slide the Upright Cover (87) upward onto the
Upright (86) as shown.
Have a second person hold the Upright (86) near
the Base (94).
See the inset drawing. Tie the wire tie in the
Upright (86) securely around the end of the
Upright Wire (79). Then, pull the other end of the
wire tie until the Upright Wire is routed through
the Upright.
3. Hold the Upright (86) against the Base (94). Be
careful not to pinch the Upright Wire (79).
Insert three 3/8" x 2 3/4" Screws (7) with three
3/8" Star Washers (11) into the Upright.
Partially tighten the 3/8" x 2 3/4" Screws (7) until
the heads of the Screws touch the Upright (86);
do not fully tighten the Screws yet.
2
Wire
Tie
86
Hole
Wire
Tie
79
3
8
86
79
86
79
94
11
94
87
Hole
7