Healthrider H145t Treadmill Manual page 21

THE INFORMATION MODE
The console features an information mode that keeps
track of treadmill information and allows you to person-
alize console settings.
1. Select the information mode.
To select the information mode, hold down the Stop
button while inserting the key into the console, and
then release the Stop button. When the information
mode is selected, the following information will be
shown:
The Time display will
show the total number
of hours that the tread-
mill has been used.
The Distance display
will show the total
number of kilometers or
miles that the walking
belt has moved.
2. Select the optional screens.
While the information mode is selected, press the
decrease button next to the Enter button to select
each of the following screens in the center display:
UNITS——To change the
unit of measurement,
press the Enter but-
ton. To view distance in
miles, select ENGLISH.
To view distance in
kilometers, select METRIC.
DEMO MODE——The console features a display
demo mode, designed to be used if the treadmill
is displayed in a store. While the demo mode is
turned on, the console will function normally when
you plug in the power cord, press the power switch
into the reset position, and insert the key into the
console. However, when you remove the key, the
displays will remain lit, although the buttons will not
function. If the demo mode is turned on, the word
ON will appear in the center display. To turn on or
turn off the demo mode, press the Enter button.
CONTRAST LVL——Press the Incline increase and
decrease buttons to adjust the contrast level of the
displays.
If a module is connected, you may also select
the following screens:
MODULE——If an iFit module is connected, the
display will show the word WIFI. If a USB module is
connected, the display will show the word USB/SD.
AUDIO COACH——To turn on or turn off the audio
coach, press the Enter button.
If an iFit module is connected, you may also
select the following screens:
START MODE——The start mode will appear when
you insert the key into the console. Press the Enter
button to select the manual mode or the iFit mode
as the start mode.
CHECK WIFI——Press the Enter button. The center
display will show the software version number,
the network SSID, the network encryption type,
the wireless signal strength, the IP address of
the module, the number of registered users and
their names, and the results of the DNS lookup.
To return to the information mode, remove the key
from the console and repeat the instructions near
the beginning of this page.
SEND/OBTAIN DATA——To send and receive work-
outs, workout logs, and updates, press the Enter
button. When the process is finished, the words
TRANSFERS DONE will appear in the display.
3. Exit the information mode.
To exit the information mode, remove the key from
the console.
21